TCPIP How To fix The IP in uRemote

Home Page Forums Cymatic Audio Forum Suggestion Box TCPIP How To fix The IP in uRemote

This topic contains 2 replies, has 2 voices, and was last updated by Fritz König Fritz König 2 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #41087
    Fritz König
    Fritz König
    Participant

    Is there a possibility to select the ip number in uTool manually?

    I use uTool often in networks with more than one ip-circuits (and network-cards).
    In this case uTool Often can not find the player/recorder. The hardware is visible with “ping” but uTool did not react.
    After disconnecting all networks and only use the uTool-net it works. After reconnecting the other networks it stays until i reopen uTool.

    • This topic was modified 2 months, 1 week ago by Laszlo . Laszlo.
    #41093
    Laszlo .
    Laszlo
    Keymaster

    Is this a uRemote topic right?
    There’s a way to set up fix IP address for uTrack24, to do this you’ll need to have the 4064 firmware on your uTrack24.

    What do you mean about other network?
    What else on the another network?

    #41098
    Fritz König
    Fritz König
    Participant

    Ooops! Sorry – I mean uRemote!

    Other networks with other ip-circiuts.
    One is for DANTE/AES67-Devices, one for gear like utrack24, mixers etc. and sometimes the home or business net. In some cases I had to use more than one uTrack24 in different networks and control it from one pc.
    I tried to use a ethernetcard for every single net.
    I can ping uTrack24 but uRemote did not find it.
    If I have only one net (where uTrack24 is) it works.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.