Hardware question about uTrack-X32

Home Page Forums Cymatic Audio Forum uTrack-X32 Hardware question about uTrack-X32

This topic contains 3 replies, has 2 voices, and was last updated by Ruud van Steenis Ruud van Steenis 1 year, 4 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #29575
    Ruud van Steenis
    Ruud van Steenis
    Participant

    Hello,

    I have a (bit strange…) question about the uTrack-X32.
    I know that this module is intended to be used in existing equipment(!).
    Since I am an electronics engineer, I wondered if it would be possible to use the uTrack-X32 as a stand-alone A/D-D/A converter.
    To accomplish this, it would be necessary to know if the audio inputs and outputs are accessible on the connector of the uTrack-X32.
    Of course also the supply voltage should be taken care of.
    I know that this is a rather unusual question, but if the X32 has analog inputs and outputs, this should be possible.
    Hope you can give me an answer!

    #29646
    Ruud van Steenis
    Ruud van Steenis
    Participant

    Nobody (from the technical staff) knows more about this? Strange…

    #29647
    Chetan
    Chetan
    Participant

    Hi,

    The uTrack-X32 sends/receives digital signal to/from the X32, so there is no A/D-D/A conversion happening inside the card.
    Even though X32 has analog inputs and outputs, they are not connected to the card.

    #29648
    Ruud van Steenis
    Ruud van Steenis
    Participant

    Thanks for your answer. That explains it all!

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.