Mix to headphones

Home Page Forums Cymatic Audio Forum uTool Mix to headphones

This topic contains 8 replies, has 3 voices, and was last updated by Laszlo . Laszlo 5 days, 9 hours ago.

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #46803
    Tag Gross
    Tag Gross
    Participant

    I have setup 4 audio tracks and a click track. How can I route 1-4 to the left side of the headphones and the click to The right side?

    #46974
    Laszlo .
    Laszlo
    Keymaster

    Hi,

    During the song creation in uTool you will have an option to open the mixer layout. Here you can set panorama for each track

    #48307
    Tag Gross
    Tag Gross
    Participant

    I do not have any pan controls in the mixer layout

    #48374
    Laszlo .
    Laszlo
    Keymaster

    Hello,

    Is your mixer layout looks like this?:
    uTool mixer

    #48499
    Tag Gross
    Tag Gross
    Participant

    Hi Lazlo:

    Thank you for your help. That is what my mixer window looks like but I only see pan controls when I have it in stereo playback. I would like to have post fader levels feeding the outputs and be able to pan left or right for the headphone feed. The end result being that I am sending the mono signal down the corresponding output and all the tracks to the left side of headphone and the click to the right side.

    #48563
    Tag Gross
    Tag Gross
    Participant

    I was also curious why there may be a discrepancy on the output level of the Cymatic as compared to Ableton through an interface even though all of the levels are set the same.

    #49977
    Tag Gross
    Tag Gross
    Participant

    Any ideas what I am doing wrong?

    #57650
    Karel Pomeisl
    Karel Pomeisl
    Participant

    Please help me. The architecture of uTool 2 mixer seems to be complicated a litlle bit for me. I need to set up a monitoring of sound throuh my headphone in different way then the sound on outputs. If I set pre or post-fader functions with various combinations of fader levels the sound on outputs and headphones is same. For example, I need hear only chanel 1 and 2 in my headphones. Simultaneously, The sound on channel 3 and 4 should be directed to the corresponding outputs 3 and 4. Is there any chance to set up these differences in headphone monitoring and outputs ? Thanx.

    #60254
    Laszlo .
    Laszlo
    Keymaster

    Hello,

    The headphones and main outputs are using the same mixer and same signal, there’s no way to create two different mixes

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.