uTrack 24 wont sync externally to my ADAT in interface mode @ 96khz

Hi Laszlo, thank you for your reply!

I am currently using OS X 10.12.6 (Sierra). My firmware is the most updated version for the device to date (4064).

Also, as an update to this post. I was able to get the external ADAT preamp to sync via word clock out of the uTrack. HOWEVER now the ADAT channels are duplicated when in 96khz mode on the interface (I believe channels 7 and 8 are duplicated to as channel 5-6, 7-8). I also cannot use channels 3,4 at all via ADAT in interface mode. I am connected in SMUX typical protocol (two optical toslink cables into ADAT channels 1-2 on the interface). Also, when the interface starts in 96khz interface mode there is a lot of digital noise for a few seconds. Everything works fine in 48khz, as well as all modes in standalone.

Thanks!