extremely clipping by uTools

Home Page Forums Cymatic Audio Forum uTool extremely clipping by uTools

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #27036
    EmmerichEmmerich
    Participant

    I take wave-files recorded by LR-16 and use them (by using uTools) for the LP-16. No problems.
    I take other wave-files, prepare them by uTools for LP-16 and get extremely clipping.
    It looks (and sounds) like, as there would be cutted the upper 8 bits of 16 bits (or 32 to 16)
    What´s going on, what can I do?

    Excuse my bad english.

    #27037
    Laszlo .Laszlo
    Keymaster

    Hi Walter,

    Please check your mixer setting in the uTool, and also check the LP-16 settings the outputs are pre or post fade.
    You can try to reduce the levels in the mixer if you want to use post-fade outputs or set the LP-16 outputs to pre-fade in this case not necessary to reduce the mixer levels.

    #27048
    EmmerichEmmerich
    Participant

    Hi Laszlo,
    thanks for your answer.
    I tried both proposels, but there was no change. Absolutely the same problem.
    Could it be, that uTools only works with wav-files, witch have been made by the cymatic LR16 ?

    #27050
    Laszlo .Laszlo
    Keymaster

    Can you please send me one channel wav file using dropbox etc to support@cymaticaudio.com ?
    I’ll take a look and let you know.
    Thanks

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.