Home Page › Forums › Cymatic Audio Forum › uTrack-X32 › Hardware question about uTrack-X32
- This topic has 3 replies, 2 voices, and was last updated 5 years, 1 month ago by
Ruud van Steenis.
- AuthorPosts
- 20th March 2018 at 15:06 #29575
Ruud van Steenis
ParticipantHello,
I have a (bit strange…) question about the uTrack-X32.
I know that this module is intended to be used in existing equipment(!).
Since I am an electronics engineer, I wondered if it would be possible to use the uTrack-X32 as a stand-alone A/D-D/A converter.
To accomplish this, it would be necessary to know if the audio inputs and outputs are accessible on the connector of the uTrack-X32.
Of course also the supply voltage should be taken care of.
I know that this is a rather unusual question, but if the X32 has analog inputs and outputs, this should be possible.
Hope you can give me an answer!15th April 2018 at 22:32 #29646Ruud van Steenis
ParticipantNobody (from the technical staff) knows more about this? Strange…
16th April 2018 at 11:23 #29647Chetan
ParticipantHi,
The uTrack-X32 sends/receives digital signal to/from the X32, so there is no A/D-D/A conversion happening inside the card.
Even though X32 has analog inputs and outputs, they are not connected to the card.16th April 2018 at 11:53 #29648Ruud van Steenis
ParticipantThanks for your answer. That explains it all!
- AuthorPosts
- You must be logged in to reply to this topic.