Led’s blincking quite always red!!!

Home Page › Forums › Cymatic Audio Forum › uTrack 24 › Led’s blincking quite always red!!!

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 29th September 2016 at 20:57 #27382
    marco
    Participant

    HI!
    Is it normal that the leds blincks quite always red?
    Even if i set the output attenuation to -30dB?
    My audio tracks are rendered to a maximum volume of -0.5 dB but the most are about – 6.0 dB!

    Thanks

    20th October 2016 at 18:11 #27483
    Laszlo
    Keymaster

    Hi giusfredi,

    Sorry for the delayed response.
    If you set output attenuation that will be not make any difference in the LED display. They are show the value before the output attenuation.
    But you can switch the uTrack24 to post fader mode (Menu/Playback/Multitrack mode options/Outputs) in this case the LED’s will show the post fader value.
    With this setup you will be enable the function where the uTrack24 DB25 output levels will follow the mixer levels from uTool.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.