Home Page › Forums › Cymatic Audio Forum › uTool › Mix to headphones
- This topic has 8 replies, 3 voices, and was last updated 4 years ago by
Laszlo.
- AuthorPosts
- 9th April 2019 at 18:29 #46803
Tag Gross
ParticipantI have setup 4 audio tracks and a click track. How can I route 1-4 to the left side of the headphones and the click to The right side?
16th April 2019 at 09:58 #46974Laszlo
KeymasterHi,
During the song creation in uTool you will have an option to open the mixer layout. Here you can set panorama for each track
6th May 2019 at 21:53 #48307Tag Gross
ParticipantI do not have any pan controls in the mixer layout
7th May 2019 at 15:09 #48374Laszlo
KeymasterHello,
Is your mixer layout looks like this?:
9th May 2019 at 00:26 #48499Tag Gross
ParticipantHi Lazlo:
Thank you for your help. That is what my mixer window looks like but I only see pan controls when I have it in stereo playback. I would like to have post fader levels feeding the outputs and be able to pan left or right for the headphone feed. The end result being that I am sending the mono signal down the corresponding output and all the tracks to the left side of headphone and the click to the right side.
9th May 2019 at 17:16 #48563Tag Gross
ParticipantI was also curious why there may be a discrepancy on the output level of the Cymatic as compared to Ableton through an interface even though all of the levels are set the same.
24th May 2019 at 21:07 #49977Tag Gross
ParticipantAny ideas what I am doing wrong?
1st September 2019 at 15:19 #57650Karel Pomeisl
ParticipantPlease help me. The architecture of uTool 2 mixer seems to be complicated a litlle bit for me. I need to set up a monitoring of sound throuh my headphone in different way then the sound on outputs. If I set pre or post-fader functions with various combinations of fader levels the sound on outputs and headphones is same. For example, I need hear only chanel 1 and 2 in my headphones. Simultaneously, The sound on channel 3 and 4 should be directed to the corresponding outputs 3 and 4. Is there any chance to set up these differences in headphone monitoring and outputs ? Thanx.
15th September 2019 at 11:29 #60254Laszlo
KeymasterHello,
The headphones and main outputs are using the same mixer and same signal, there’s no way to create two different mixes
- AuthorPosts
- You must be logged in to reply to this topic.