Home Page Forums Cymatic Audio Forum uTrack 24 Problem when reconnecting unit 1 in redundant rig

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #27740
    Axel
    Participant

    Hej!
    I use two u24 in sync.

    In playlist mode when I pull out the usb stick from player 1 (to simulate a critical failure) , player 2 continues playing as it should.

    When I put the stick back in machine 1 however (to simulate that it starts working), it makes both machines go to multitrack mode which is bad..

    How can I make machine 1 catch up (both in mode and time, if that makes sense) instead of throwing machine 2off when it comes back?

    Thank you in advance!
    /Axel Fagerberg
    Percussion.se

    #27753
    Laszlo
    Keymaster

    Hi Axel,

    In sync group the Slave uTrack24 all the time follows the Master.
    So if you have the sync group then you disconnect the master the slave take over and keep playing back. If you connect back the master then you don’t load the playlist on the master in this case the playlist will unloaded on the slave as well, because the slave follows the master.
    If you do the same test where you disconnect the slave instead of the master you shouldn’t have this issue right?

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.