Home Page › Forums › Cymatic Audio Forum › uTrack-X32 › Problem with URemote and Utrack24 Mixer
Tagged: Utrack24 Uremaote
- This topic has 2 replies, 2 voices, and was last updated 4 years, 8 months ago by
Laszlo.
- AuthorPosts
- 16th January 2019 at 09:55 #44338
Maria Huehn
ParticipantHello,
ic was able to connect the Utrack to my Ipad 2 via Wifi.
When i start The URemote tool. It detects the Utrack and I can Start/Stop the tracks and see the Meter.But the mixer does not work at all. I can move the faders as I want or press “Mute”/”Solo” on a track with noch effect. The Audio stays the same.
What am I missing here?
Wishes,
Maria16th January 2019 at 11:38 #44341Maria Huehn
ParticipantAddenum: after reading alot, is it possible that all these Settings only apply to the STEREO OUT of the Utrack and not on the individual channels? If so this would be a BIG Bummer for the device.
16th January 2019 at 15:47 #44348Laszlo
KeymasterHello,
By default if you adjust the mixer that will adjust the volume only in the downmix of the channels (headphones out and main out 1-2), if you would like to adjust the levels on the DB25 outputs, you’ll need to switch the uTrack24 to post fader mode. (menu/playback/multitrack mode option/outputs: pre or post)
-if you enable the pre-fader mode in the uTrack24 menu, in this case the mixer parameters applied only on the headphones out and the stereo out on the back panel.
-if you enable the post-fader mode in the uTrack24 menu, in this case the mixer parameters applied on the headphones out as well DB25 outputs. - AuthorPosts
- You must be logged in to reply to this topic.