Static IP Adres

Home Page Forums Cymatic Audio Forum uTrack 24 Static IP Adres

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #26127
    GuidoGuido
    Participant

    Hi,

    We want to use the uTrack24 just with the pc URmote software. (no via WiFi) We connected the pc directly via RJ-45 ethernet socket but we found out it does not have a fixed ip adres. Is there a possibility to set a fixed ip, or do we always need a router to create a local network?

    kr
    Guido

    #26128
    Laszlo .Laszlo
    Keymaster

    3.1 Network Setup

    • Set up a wireless router, to create a local wireless network. For stage use, one popular
    • choice is a “travel wireless router” where the router is very compact and has a built in power
      plug, no external power cables required.

    • Connect a standard RJ-45 network cable between the network port on the rear panel of
    • your uTrack 24, and one of the LAN (Local Area Network) ports of your router. Your router
      will automatically assign an IP (Internet Protocol) address to the attached uTrack 24.

    • Connect your computer, tablet, or smartphone to the network that is being provided by the
    • router. Note that multiple devices may all run uRemote at the same time and all control a
      single uTrack 24 simultaneously.

      ? With a laptop or desktop computer, the connection to the router’s network can be
      wired or wireless.
      ? With a smartphone or tablet, the connection would be wireless.

    • If you have set up everything correctly, upon the first launch of uRemote, the software will
    • automatically discover your uTrack 24 interface and display uRemote’s “home screen”.

    • You are now ready to start using uRemote, no further steps required!mote, no further steps required!

    You can use direct connection between the PC and the uTrack after installing the CopperLan package on your computer. In this case, the communication between uRemote and the uTrack goes through the CopperLan network, and so no IP address is needed to get it working.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.