Home Page › Forums › Cymatic Audio Forum › uTrack 24 › Synchronization
- This topic has 6 replies, 4 voices, and was last updated 6 years, 9 months ago by
Paolo Torquati.
- AuthorPosts
- 15th April 2015 at 02:02 #25945
Jan
Participant/15th April 2015/
Hi Cymatic!Please, is there any possibility to control the uTrack not only via using the uRemote? E.g. – Can I send any ethernet command direct via RJ45 or the PS/2 connector?
How looks the situation around MIDI output? Unfortunatelly, It is still dead 🙁 You wrote that uTrack will start MIDI output with the new firmware. Do you have any idea about ETA??
Thank you,
best regards!15th April 2015 at 02:26 #25946Tom Sailor
ParticipantI’m not entirely clear what you are asking as the title is about synchronization…
The uRemote app is also available for Mac and PC which will connect over standard LAN as well.
4th March 2016 at 13:33 #26859Paolo Torquati
ParticipantIs it possible to connect directly via ethernet but without router
Regards
8th March 2016 at 11:24 #26866Laszlo
KeymasterYes, you can connect the uTrack24 directly to the PC/MAC with no rourter. Please make sure, your PC/MAC configured to DHCP.
7th December 2016 at 16:58 #27660Paolo Torquati
ParticipantHi again.
If I want to setup a redundant system with two Utrack24 in sync via ethernet cable, and also want to use Uremote on a laptop, via ethernet, will it work if they are connected via a LAN-switch?Regards
Paolo7th December 2016 at 18:07 #27662Laszlo
KeymasterHi
The uTrack24 will using AutoIP if there’s no DHCP router on the network.
So you can use switch.7th December 2016 at 18:25 #27664Paolo Torquati
ParticipantPerfect, thanx 😉
Have a great day - AuthorPosts
- You must be logged in to reply to this topic.